Bad modemīad modem if you hear dial tone and Modem not Dial Verifies sound system and modem are communicating At bottom left hand corner itĩ) Tap the Space Bar once. Set Speaker volume on HighĨ) Push Dial (should hear dialing) push Cancel. Remove the check mark in 'Wait for dial tone before dialing'.ĥ)Click on General Tab.

Click the Modify button, Configure button, and the Connection tab.ĤB. Phone line for the modem, jump to step 4A)ĤA. It does not seem to implement any official remote programming interface itself like ActiveX or even true old fashioned and completely obsolete DDE.ĭocumentation on Hyperterminal beyond use as a terminal program is sparse to non existent.1) Click on START/PROGRAMS/ACCESSORIES/HYPERTERMINALĢ) Double click on Hypertrm (phone connected to a monitor).ģ) At New Connection insert a name and click OK.Ĥ) Enter any seven digit number and click OK. Okay a lot of people have been asking me for this information. So basically the only way to control it would seem to be through applications like AutoIt or similar that simulate GUI interaction to a program. I constantly get asked if I know the Hyper Terminal commands for the Fire Control Instruments (FCI) E3. In this post I have put down a few to get you guys started. I will try to get more and update this list as they are found. When using other terminal emulation applications you might have some more success although there is none that I know of that supports a fully open remote control API. Teraterm has a macro application that you can call through System Exec.Basically it is a sort command line version of Teraterm that you can call with command line parameters to execute. Works fine for simple tasks like connecting to a target and executing a few commands, but not for a lengthy data exchange with the device that requires to go back and forth between LabVIEW (or any other application) and the Teraterm Macro executable. Putty is another possibility with similar limitations. Press the UP arrow key to view the command that was entered most recently in the session. Putty can be integrated with LabVIEW through use of standard IO redirection to Pipes, and I have developed an OpenG library to do this redirection but it never quite got fully tested and released.

Use the UP and DOWN arrow keys to scroll through a list of up to ten previous commands.

Type at least one letter of a command and press the TAB key to scroll through a list of valid commands that match the text you typed in the command line. In the meantime some other people have developed. Net based pipe redirection interfaces which might be able to do that.

Hyperterminal command list